Voltage Sub-Register; Temperature Sub-Register - Ametek Sorensen XG Operation Manual

Remote Operation

VOLTage Sub-Register

This shows whether the present voltage level is over or under the
specified trip limit.
Table 5-16 QUEStionable VOLTage Status Register
Bit Bit Weight Bit Name
0 1 OVP
1 2 UVP

TEMPerature Sub-Register

This shows whether the temperature of critical components is near or
over the maximum operating temperature.
Table 5-17 QUEStionable TEMPerature Status Register
Bit
Bit Weight Bit Name
0 1 OTP
Reading Internal Temperature Measurements
Internal temperatures are measured by the channels of a fan controller.
The XG/XTR 850 has one fan controller, Fan0, with two channels, 0
and 1, that each control a fan and measure temperature. The XG/XTR
1700 has two fan controllers, Fan0 with two channels, 0 and 1, and Fan1
with two channels, 0 and 1 (four fans total).
The SCPI command (s) for these readings are:
DIAGnostic:MEMory:FAN<n>:READ #h0<n>
Example: to read the temperatures in the XG/XTR 850,
DIAG:MEM:FAN0:READ #h00
DIAG:MEM:FAN0:READ #h01
To read temperatures in the XG/XTR 1700 send either or both of the
above example commands for the channel(s) of the first fan, and input
FAN1
the channel(s) of the second fan.
5-50
Description
Over Voltage Protection
Under Voltage Protection
Description
Over Temperature Protection
FAN0
in place of to read the temperature measurements taken by
//this reads the 1st channel
//this reads the 2nd channel
M370430-01 Rev B