Normal Display Mode And Inactivity Timeout - Ametek Sorensen XG Operation Manual

Normal Display Mode and Inactivity Timeout

The SCPI command (s) for these instructions are:
[:]SYSTem[<channel>]:FPANel[:TIMeout]
Important: Each user memory setting location stores the timeout so that
beginning users and expert users are not required to use the same timeout
M370430-01 Rev B
Normal display mode appears on the output voltage and current
displays when the configuration changes from the front panel have
been completed or when the inactivity timeout occurs (default is 3
seconds). Normal display mode shows the output voltage and
current values.
If a timeout occurs before the changes made to the value have been
set, the changes will not be saved and you will have to re-enter the
changes. The inactivity timeout is variable from 1 to 20 seconds
and can only be changed using the SCPI command.
Local Operation
3
3-7