Voltage And Current Mode Operation Checks - Ametek Sorensen XG Operation Manual

Voltage and Current Mode Operation Checks

To perform the voltage and current mode operation checks:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Connect a short circuit across the output terminals. Use leads
11. Press the OUTPUT ENABLE Main button to enable the
12. Turn the front panel power switch to the Off position.
M370430-01 Rev B
Ensure that the front panel power switch is in the On position
and the output is disconnected.
If the OUTPUT ENABLE Main button is illuminated, press
the button to turn off the output.
To check voltage mode operation, turn the 9-position mode
control to the VOLTS position.
The voltage set point will blink dimming and then return to full
brightness. For more information, see "Local Operation" on page
3-1.
Adjust the voltage to 5 V.
To check current mode operation, turn the 9-position mode
control to AMPS position.
Verify that the current set point is blinking in the output current
display.
Adjust the current to 1 A.
Press the OUTPUT ENABLE Main button to turn On.
Turn the front panel power switch to the Off position.
Turn the front panel power switch to the On position.
of sufficient current carrying capacity. (See "Step 4: Selecting
Load Wires".)
output. The button will be illuminated when the output is
enabled.
CC Mode LED illuminates and the voltage and current are
displayed. CC Mode LED illuminates and the preset load current is
displayed.
Installation
2
2-11