Window - Ametek Sorensen XG Operation Manual

Communications Options
Figure 6-33 shows the system of a unit with the ENET option and
several units connected via the RS-485 bus. Each power supply must
have its own address, defined from the front panel. Only one IP address
is required for your network (excluding computers) and only one
controlling program is required (one per unit with ENET option as noted
in "Network Topology 1: Simple LAN" on page 6-24).
Figure 6-33 ENET and RS-485 Bus
Figure 6-34 HyperTerminal Window
Figure 6-34 shows the HyperTerminal session for the combined
configuration which is an ENET and RS-485 network. This figure also
shows access to power supplies #2 and #10 sequentially.
Setting Up Your System
To set up your system:
6-28
Local Computer
ENET
RS-485
IN OUT IN
Power Supply #1
Power Supply #2
RS-485
OUT IN
Power Supply #30
M370430-01 Rev B
OUT