Step 1: Inspecting And Cleaning; Initial Inspection; Periodic Cleaning - Ametek Sorensen XG Operation Manual

Step 1: Inspecting and Cleaning

Initial Inspection

When you first receive your unit, perform a physical check:
1.
2.
3.

Periodic Cleaning

The power supply only requires periodic cleaning, not routine servicing.
Whenever a unit is removed from operation, clean the metal surfaces
with naptha or an equivalent solvent, and clean the front panel with a
weak solution of soap and water. Use low-pressure compressed air to
blow dust from components on the printed circuit boards.
M370430-01 Rev B
Inspect the unit for any scratches and cracks, broken switches,
connectors or displays.
Ensure that the packing box contains the 7.5 foot (2.5 m)
power cord (supplied with the XG/XTR 850 W model only).
If you see external damage or suspect internal damage,
contact the carrier immediately.
Installation
2
2-3