System Parameters; Table 4-2: System Parameters - AudioCodes Mediant 1000 User Manual

SIP User's Manual
4.4.2

System Parameters

ini File Parameter
GroundKeyDetection
EnableDiagnostics
WatchDogStatus
LifeLineType
GWAppDelayTime
Version 5.4

Table 4-2: System Parameters

Enables analog ground-key detection (FXS and FXO modules implement
ground-start signaling) per device. When disabled, the device uses loop-
start signaling.
[0] = Disable (default)
[1] = Enable (enables ground start)
Notes:
This parameter is applicable only to Mediant 1000.
For ground-start signaling, ensure that the FXO G module is installed
(and not the regular FXO module) in the Mediant 1000 chassis.
For FXO ground-start signaling, ensure that the parameters
EnableCurrentDisconnect is set to 1 and FXOBetweenRingTime is set
to 300.
Checks the correct functionality of the different hardware components on
the device. On completion of the check, if the test fails, the device sends
information on the test results of each hardware component to the Syslog
server.
[0] = Rapid and Enhanced self-test mode (default).
[1] = Detailed self-test mode (full test of DSPs, PCM, Switch, LAN,
PHY and Flash).
[2] = A quicker version of the Detailed self-test mode (full test of
DSPs, PCM, Switch, LAN, PHY, but partial test of Flash).
For detailed information, refer to the Product Reference Manual.
[0] = Disable device's watch dog.
[1] = Enable device's watch dog (default).
Note: This parameter is applicable only to Mediant 1000.
Defines the Lifeline phone type. The Lifeline phone is available on port 1
of each analog module.
The Lifeline is activated upon one of the following options:
[0] = Power down (default).
[1] = Power down or when link is down (physical disconnect).
[2] = Power down or when link is down or on network failure (logical
link disconnect).
Notes:
This parameter is applicable only to Mediant 1000.
To enable Lifeline switching on network failure, LAN watch dog must
be activated (EnableLANWatchDog = 1).
This parameter is only applicable to FXS interface.
For a description of this parameter, refer to ''Advanced Parameters'' on
page 166.
305
4. ini File Configuration
Description
May 2008