AudioCodes Mediant 1000 User Manual page 187

SIP User's Manual
Parameter
Transfer
Blind
[KeyBlindTransfer]
Call Waiting (Note: The call waiting can be viewed in the 'Call Waiting' table - refer to ''Call Waiting''
on page 440.)
Activate
[KeyCallWaiting]
Deactivate
[KeyCallWaitingDeact]
Reject Anonymous Call
(Note: You can reject anonymous calls per FXS interface, using RejectAnonymousCallPerPort - refer
to ''Analog Telephony Parameters'' on page 355.)
Activate
[KeyRejectAnonymous
Call]
Deactivate
[KeyRejectAnonymous
CallDeact]
Version 5.4
Keypad sequence that activates blind transfer for Tel-to-IP calls. There are
two possible scenarios:
Option 1: After this sequence is dialed, the current call is put on hold
(using Re-INVITE), a dial tone is played to the phone, and then phone
number collection starts.
Option 2: A Hook-Flash is pressed, the current call is put on hold, a dial
tone is played to the phone, and then digit collection starts. After this
sequence is identified, the device continues the collection of the
destination phone number.
For both options, after the phone number is collected, it's sent to the
transferee in a SIP REFER request (without a Replaces header). The call is
then terminated and a confirmation tone is played to the phone. If the
phone number collection fails due to a mismatch, a reorder tone is played
to the phone.
Notes:
This parameter is applicable to FXO and FXS interfaces, but for FXO
the Web interface does not display this parameter.
It is possible to configure whether the KeyBlindTransfer code is added
as a prefix to the dialed destination number, by using the parameter
KeyBlindTransferAddPrefix (refer to ''Channel Parameters'' on page
377).
Keypad sequence that activates the Call Waiting option. After the sequence
is pressed, a confirmation tone is heard.
Keypad sequence that deactivates the Call Waiting option. After the
sequence is pressed, a confirmation tone is heard.
Keypad sequence that activates the reject anonymous call option, whereby
the device rejects incoming anonymous calls. After the sequence is
pressed, a confirmation tone is heard.
Keypad sequence that de-activates the reject anonymous call option. After
the sequence is pressed, a confirmation tone is heard.
Description
187
3. Web-Based Management
May 2008