AudioCodes Mediant 1000 User Manual page 67

SIP User's Manual
Parameter
Control Network Settings (Available only in Multiple IP and Dual IP modes.)
IP Address
[LocalControlIPAddress]
Subnet Mask
[LocalControlSubnetMask]
Default Gateway Address
[LocalControlDefaultGW]
Media Network Settings (Available only in Multiple IP and Dual IP modes.)
IP Address
[LocalMediaIPAddress]
Subnet Mask
[LocalMediaSubnetMask]
Default Gateway Address
[LocalMediaDefaultGW]
Multiple Interface Settings
Multiple Interface Table
VLAN (For detailed information on the device's VLAN implementation, refer to ''VLANS and Multiple
IPs'' on page 450.)
VLAN Mode
[VlANMode]
VALN ID Settings
Native VLAN ID
[VLANNativeVlanID]
OAM VLAN ID
[VLANOamVlanID]
Control VLAN ID
[VLANControlVlanID]
Media VLAN ID
[VLANMediaVlanID]
NAT Settings
NAT IP Address
[StaticNatIP]
Version 5.4
The device's source IP address in the Control network.
The default value is 0.0.0.0.
The device's subnet mask in the Control network.
The default subnet mask is 0.0.0.0.
N/A. Use the IP Routing table instead (refer to ''Configuring the IP
Routing Table'' on page 75).
The device's source IP address in the Media network.
The default value is 0.0.0.0.
The device's subnet mask in the Media network.
The default subnet mask is 0.0.0.0.
The device's default Gateway IP address in the Media network.
The default value is 0.0.0.0.
Click the right-pointing arrow
Table' page. For a description of configuring multiple IP interfaces, refer
to ''Configuring the Multiple Interface Table'' on page 68.
Enables the VLAN functionality.
[0] Disable (default).
[1] Enable.
[2] PassThrough = N/A.
Note: This parameter cannot be changed on-the-fly and requires a
device reset.
Defines the native VLAN identifier (Port VLAN ID - PVID).
The valid range is 1 to 4094. The default value is 1.
Defines the OAMP VLAN identifier.
The valid range is 1 to 4094. The default value is 1.
Defines the Control VLAN identifier.
The valid range is 1 to 4094. The default value is 2.
Defines the Media VLAN identifier.
The valid range is 1 to 4094. The default value is 3.
Global (public) IP address of the device to enable static Network
Address Translation (NAT) between the device and the Internet.
67
3. Web-Based Management
Description
button to open the 'Multiple Interface
May 2008