Figure 3-94: Ip Group Table - AudioCodes Mediant 1000 User Manual

SIP User's Manual
3.4.5.7.3 Configuring the IP Groups
The 'IP Group Table' page allows you to create logical IP entities (IP Groups) that are later
used in the call routing tables.
The IP Groups are typically implemented in Tel-to-IP call routing. The IP Group can be
used as a destination entity (DestIPGroupID) in the 'Tel to IP Routing' table, and
ServingIPGroupID in the 'Trunk Group Settings' (refer to ''Configuring the Trunk Group
Settings'' on page 228) and 'Account' (refer to ''Configuring the Account Table'' on page
232) tables. These call routing tables are used for identifying the IP Group from where the
INVITE is sent for obtaining a digest user/password from the 'Account' table if there is a
need to authenticate subsequent SIP requests in the call. The IP Group can also be
implemented in IP-to-Tel call routing as a source IP Group (SourceIPGroupID).
The IP Groups are assigned various entities such as a Proxy Set ID, which represents an
IP address (created in ''Proxy Sets Table'' on page 153). You can also assign the IP Group
with a host name and other parameters that reflect parameters sent in SIP Request
From\To.
Notes:
To configure IP Groups, take these 4 steps:
1. Open the 'IP Group Table' page (Configuration tab > Protocol Configuration menu
> Trunk/IP Group submenu > IP Group Table page item).
2. Configure the IP group parameters according to the table below.
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, refer to ''Saving Configuration'' on page 265.
Version 5.4
•
By default, if you disable the use of a proxy (i.e., IsProxyUsed is set to 0),
then only one IP Group is defined (and working with multiple IP Groups is
not valid).
•
You can also configure the IP Groups table using the ini file table
parameter IPGroup (refer to ''SIP Configuration Parameters'' on page
323).
Figure 3-94: IP Group Table Page
231
3. Web-Based Management
May 2008