Integrating Using The Ini File; Figure 8-5: Static Routes For Oam/Control In Ip Routing Table - AudioCodes Mediant 1000 User Manual

5. Configure the 'IP Routing' table to define static routing rules for the OAMP and Control
networks, since a default gateway isn't supported on these networks:
a. Open the 'IP Routing Table' page (refer to ''Configuring the IP Routing Table'' on
page 75).

Figure 8-5: Static Routes for OAM/Control in IP Routing Table

b. Use the Add New Entry to add the routing rules listed in the following table:
Destination IP Address
87.66.15.8
85.44.115.50
6. Save your changes to flash memory (refer to ''Saving Configuration'' on page 265) and
reset the device (refer to ''Resetting the Device'' on page 262).
8.9.3.2

Integrating Using the ini File

The procedure below describes how to integrate the device into a multiple IPs network with
VLANs, using the ini file. The procedure below is based on the example setup described in
''Getting Started with VLANS and Multiple IPs'' on page 453.
To integrate the device into a multiple IPs network withVLANs
using the ini file, take these 3 steps:
1. Prepare an ini file (using the ini file table parameter InterfaceTable) with relevant
parameters:
•
If the BootP/TFTP utility and the OAMP interface are located on the same
network, the Native VLAN ID (VlanNativeVlanId) must be equal to the OAMP
VLAN ID (VlanOamVlanId), which in turn must be equal to the PVID of the switch
port to which the device is connected. Therefore, set the PVID of the switch port
to 4 (in this example).
•
Configure the OAMP parameters only if the OAMP networking parameters are
different from the networking parameters used in the Single IP Network mode.
•
The 'IP Routing' table is required to define static routing rules for the OAMP and
Control networks since a default Gateway isn't supported for these networks.
SIP User's Manual
Destination Mask Gateway IP Address
255.255.255.255
255.255.255.0
456
Mediant 1000 & Mediant 600
Hop Count
10.13.0.1 20
10.31.0.1 20
Document #: LTRT-83303
Interface
Control
OAMP