AudioCodes Mediant 1000 User Manual page 346

ini File Parameter
ISDNRxOverlap_x
ISDNRxOverlap
R2Category
HeldTimeout
CallPriorityMode
MLPPDefaultNamespace For a description of this parameter, refer to "Configuring the Digital
SIPDefaultCallPriority
MLPPDiffserv
PreemptionToneDuration Defines the duration (in seconds) in which the device plays a preemption
TrunkLifeLineType
TrunkAdministrativeState Defines the administrative state of a trunk.
SIP User's Manual
For a description of this parameter, refer to "Configuring the Trunk
Settings" on page 96.
[0] = Disabled (default).
[1] = Enabled.
Any number bigger than one = Number of digits to receive.
Notes:
If enabled, the device receives ISDN called number that is sent in the
'Overlap' mode.
The INVITE to IP is sent only after the number (including 'Sending
Complete' Info Element) was fully received (in SETUP and/or
subsequent INFO Q.931 messages).
For detailed information on ISDN overlap dialing, refer to ISDN Overlap
Dialing on page 463.
For a description of this parameter, refer to "Configuring the Digital
Gateway Parameters" on page 235.
Determines the time period the device can remain in on-hold. If a
Resume (un-hold Re- INVITE) message is received before the timer
expires, the call is renewed. If this timer expires, the call is released.
[-1] = Indefinitely (default).
[0 - 2400] =Time to wait in seconds.
Currently, this parameter is applicable only to MFC R2 CAS variants.
Enables Priority Calls handling for analog and digital interfaces.For a
description of this parameter, refer to "Configuring the Digital Gateway
Parameters" on page 235.
Gateway Parameters" on page 235.
For a description of this parameter, refer to "Configuring the Digital
Gateway Parameters" on page 235.
For a description of this parameter, refer to "Configuring the Digital
Gateway Parameters" on page 235.
The valid range is 0 to 63. The default value is 50.
Note: This parameter is applicable to both analog and digital interfaces.
tone to both the Tel and IP sides if a call was preempted.
The valid range is 0 to 60. The default is 3.
Note: If set to 0, no preemption tone is played.
Defines the type of trunk lifeline. Short trunks 1-2, 3-4.
[0] = Activate lifeline on power down (default).
[1] = Activate lifeline on power down or on detection of LAN
disconnect.
[2] = Activate lifeline on power down or on detection of LAN
disconnect or loss of ping.
[0] = Lock the trunk; stops trunk traffic to configure the trunk protocol
type.
[2] = Unlock the trunk (default); enables trunk traffic.
346
Mediant 1000 & Mediant 600
Description
Document #: LTRT-83303