Figure 7-17: Configuring Proxy Set Id #1 In The Proxy Sets Table; Figure 7-18: Configuring Ip Groups #1 And #2 In The Ip Group Table - AudioCodes Mediant 1000 User Manual

SIP User's Manual
To configure call routing between Enterprise and two ITSPs using
the device, take these 8 steps:
1. Enable the device to register to a Proxy / Registrar server, using the parameter
IsRegisterNeeded in the 'Proxy & Registration' page (refer to ''Proxy & Registration
Parameters'' on page 146).
2. In the 'Proxy Sets Table' page (refer to ''Proxy Sets Table'' on page 153), configure
two Proxy Sets and for each, enable Proxy Keep-Alive (using SIP OPTIONS) and
'round robin' load-balancing method:
•
Proxy Set #1 includes two IP addresses of the first ITSP (ITSP 1) - 10.33.37.77
and 10.33.37.79 - and using UDP.
•
Proxy Set #2 includes two IP addresses of the second ITSP (ITSP 2) - 10.8.8.40
and 10.8.8.10 - and using TCP.
The figure below displays the configuration of Proxy Set ID #1. Perform similar
configuration for Proxy Set ID #2, but using different IP addresses.
Figure 7-17: Configuring Proxy Set ID #1 in the Proxy Sets Table Page
3. In the 'IP Group Table' page (refer to ''Configuring the IP Groups'' on page 231),
configure the two IP Groups IDs #1 and #2. Assign Proxy Sets #1 and #2 to IP Groups
#1 and #2 respectively.
Figure 7-18: Configuring IP Groups #1 and #2 in the IP Group Table Page
Version 5.4 435
7. IP Telephony Capabilities
May 2008