AudioCodes Mediant 1000 User Manual page 180

Parameter
Message Waiting Indication (MWI) Parameters
Note: MWI is applicable only to Mediant 1000.
Enable MWI
[EnableMWI]
MWI Analog Lamp
[MWIAnalogLamp]
MWI Display
[MWIDisplay]
Subscribe to MWI
[EnableMWISubscriptio
n]
MWI Server IP Address
[MWIServerIP]
MWI Server Transport
Type
[MWIServerTransportTy
pe]
MWI Subscribe
Expiration Time
[MWIExpirationTime]
SIP User's Manual
Enables Message Waiting Indication (MWI).
[0] Disable = Disabled (default).
[1] Enable = MWI service is enabled.
Notes:
This parameter is applicable only to FXS interfaces.
The device supports only the receipt of SIP MWI NOTIFY messages
(the device doesn't generate these messages).
For detailed information on MWI, refer to "Message Waiting Indication"
on page 440.
Enables visual display of MWI.
[0] Disable = Disable (default).
[1] Enable = Enables visual Message Waiting Indication by supplying
line voltage of approximately 100 VDC to activate the phone's lamp.
Note: This parameter is applicable only for FXS interfaces.
Determines whether MWI information is sent to the phone display.
[0] Disable = MWI information isn't sent to display (default).
[1] Enable = The device generates an MWI message (determined by
the parameter CallerIDType), which is displayed on the MWI display.
Note: This parameter is applicable only to FXS interfaces.
Enables subscription to an MWI server.
[0] No = Disables MWI subscription (default).
[1] Yes = Enables subscription to MWI (to MWIServerIP address).
Note: Use the parameter SubscriptionMode (described in Proxy &
Registration Parameters on page 146) to determine whether the device
subscribes per endpoint or per the entire device.
MWI server's IP address. If provided, the device subscribes to this IP
address.
The MWI server address can be configured as a numerical IP address or
as a domain name. If not configured, the Proxy IP address is used instead.
Determines the transport layer used for outgoing SIP dialogs initiated by
the device to the MWI Server.
[-1] Not Configured (default)
[0] UDP
[1] TCP
[2] TLS
Note: When set to 'Not Configured', the value of the parameter
SIPTransportType is used.
The MWI subscription expiration time in seconds.
The default is 7200 seconds. The range is 10 to 72000.
180
Mediant 1000 & Mediant 600
Description
Document #: LTRT-83303