Figure 3-93: Trunk Group Settings; Table 3-51: Trunk Group Settings Parameters Description - AudioCodes Mediant 1000 User Manual

3.4.5.7.2 Configuring the Trunk Group Settings
The 'Trunk Group Settings' page is mainly used to select the method for which IP-to-Tel
calls are assigned to channels within each Trunk Group. If no method is selected (for a
specific Trunk Group), the setting of the global parameter ChannelSelectMode in the 'SIP
General Parameters' page (refer to ''SIP General Parameters'' on page 134) applies. In
addition, this page also defines the method for registering Trunk Groups to selected
Serving IP Group IDs (if defined). You can add up to 24entries in this table.
Note:
To configure the Trunk Group Settings table, take these 5 steps:
1. Open the 'Trunk Group Settings' page (Configuration tab > Protocol Configuration
menu > Trunk/IP Group submenu > Trunk Group Settings page item).
2. From the 'Routing Index' drop-down list, select the range of entries that you want to
edit (up to 24 entries can be configured).
3. Configure the Trunk Group according to the table below.
4. Click the Submit button to save your changes.
5. To save the changes to flash memory, refer to ''Saving Configuration'' on page 265.

Table 3-51: Trunk Group Settings Parameters Description

Mode
Trunk Group ID The Trunk Group ID that you want to configure.
The valid range is 1-99.
Trunks are assigned to Trunk Groups in the 'Trunk Group Table' page (refer to
"Configuring the Trunk Group Table" on page 226).
SIP User's Manual
You can also configure the Trunk Group Settings table using the ini file table
parameter TrunkGroupSettings (refer to ''Number Manipulation and Routing
Parameters'' on page 364).
Figure 3-93: Trunk Group Settings Page
Description
228
Mediant 1000 & Mediant 600
Document #: LTRT-83303