AudioCodes Mediant 1000 User Manual page 363

SIP User's Manual
ini File Parameter
CurrentDisconnectDura
tion
CurrentDisconnectDefa
ultThreshold
TimeToSampleAnalogL
ineVoltage
AnalogCallerIDTimimg
Mode
BellcoreCallerIDTypeO
neSubStandard
ETSICallerIDTypeOneS
ubStandard
ETSIVMWITypeOneSta
ndard
Version 5.4
The duration (in msec) of the current disconnect pulse.
The range is 200 to 1500. The default is 900.
Notes:
This parameter is applicable for both FXS and FXO interfaces.
The FXO interface detection range is approximately 200 msec of the
parameter's value plus 100. For example, if CurrentDisconnectDuration
is 200 msec, then the detection range is 100 to 500 msec.
Determines the line voltage threshold which, when reached, is considered
a current disconnect detection.
The valid range is 0 to 20 Volts. The default value is 4 Volts.
Note: Applicable only to FXO interfaces.
Determines the frequency at which the analog line voltage is sampled (after
offhook), for detection of the current disconnect threshold.
The valid range is 100 to 2500 msec. The default value is 1000 msec.
Note: Applicable only to FXO interfaces.
[0] = Caller ID is generated between the first two rings (default).
[1] = The device attempts to find an optimized timing to generate the
Caller ID according to the selected Caller ID type.
Notes:
Applicable only to FXS interfaces.
When used with distinctive ringing, the Caller ID signal doesn't change
the distinctive ringing timing.
Selects the Bellcore Caller ID sub-standard.
[0] = Between rings (default).
[1] = Not ring related.
Selects the ETSI FSK Caller ID Type 1 sub-standard (FXS only).
[0] = ETSI between rings (default).
[1] = ETSI before ring DT_AS.
[2] = ETSI before ring RP_AS.
[3] = ETSI before ring LR_DT_AS.
[4] = ETSI not ring related DT_AS.
[5] = ETSI not ring related RP_AS.
[6] = ETSI not ring related LR_DT_AS.
Selects the ETSI Visual Message Waiting Indication (VMWI) Type 1 sub-
standard.
[0] = ETSI VMWI between rings (default)
[1] = ETSI VMWI before ring DT_AS
[2] = ETSI VMWI before ring RP_AS
[3] = ETSI VMWI before ring LR_DT_AS
[4] = ETSI VMWI not ring related DT_AS
[5] = ETSI VMWI not ring related RP_AS
[6] = ETSI VMWI not ring related LR_DT_AS
Description
363
4. ini File Configuration
May 2008