AudioCodes Mediant 1000 User Manual page 352

ini File Parameter
EnableAOC
PlayBusyTone2ISDN
TrunkTransferMode_X
CASTransportType
SIP User's Manual
[0] = Not used (default).
[1] = ISDN Advice of Charge (AOC) messages are interworked to SIP.
The device supports receipt of ISDN (Euro ISDN) AOC messages. AOC
messages can be received during a call (FACILITY messages) or at the
end of a call (DISCONNECT or RELEASE messages). The device
converts the AOC messages into SIP INFO (during a call) and BYE (end
of a call) messages, using a proprietary AOC SIP header. The device
supports both Currency and Pulse AOC messages.
For a description of this parameter, refer to ''SIP General Parameters'' on
page 134.
Determines the supported trunk transfer method when a SIP REFER
message is received.
[0] = Not supported (default).
[1] = Supports CAS NFA DMS-100 transfer. When a SIP REFER
message is received, the device performs a Blind Transfer by
executing a CAS Wink, waits for an acknowledged Wink from the
remote side, dials the Refer-to number to the switch, and then releases
the call.
Note: A specific NFA CAS table is required.
[2] = Supports ISDN transfer: RLT (DMS-100), TBCT (NI2), ECT
(EURO ISDN), and Path Replacement (QSIG). When a SIP REFER
message is received, the device performs a transfer by sending
FACILITY messages to the PBX with the necessary information on the
call's legs that are to be connected. The different ISDN variants use
slightly different methods (using FACILITY messages) to perform the
transfer.
[3] = Supports CAS Normal transfer. When a SIP REFER message is
received, the device performs a Blind Transfer by executing a CAS
Wink, dialing the Refer-to number to the switch, and then releasing the
call.
[4] = Supports QSIG Single Step transfer:
IP-to-Tel: When a SIP REFER message is received, the device
performs a transfer by sending a FACILITY message to the PBX,
initiating Single Step transfer. Once a success return result is received,
the transfer is completed.
Tel-to-IP: When a FACILITY message initiating Single Step transfer is
received from the PBX, a REFER message is sent to the IP side.
Notes:
To use QSIG Path Replacement, the parameter
UserToUserHeaderFormat must be set to 1.
To configure Trunk Transfer Mode using the Web interface, refer to
''Configuring the Trunk Settings'' on page 96.
For a description of this parameter, refer to ''Configuring the Voice
Settings'' on page 81.
352
Mediant 1000 & Mediant 600
Description
Document #: LTRT-83303