AudioCodes Mediant 1000 User Manual page 239

SIP User's Manual
Parameter
Enable ISDN Tunneling IP to Tel
[EnableISDNTunnelingIP2Tel]
ISDN Transfer On Connect
[SendISDNTransferOnConnect]
Remove CLI when Restricted
[RemoveCLIWhenRestricted]
Remove Calling Name
[RemoveCallingName]
Default Cause Mapping From
ISDN to SIP
[DefaultCauseMapISDN2IP]
Add Prefix to Redirect Number
[Prefix2RedirectNumber]
Version 5.4
[0] Disable = Disable (default).
[1] Using Header = Enable ISDN Tunneling from SIP to ISDN
PRI using a proprietary SIP header.
[2] Using Body = Enable ISDN Tunneling from SIP to ISDN PRI
using a dedicated message body.
When ISDN Tunneling is enabled, the device extracts raw data
received in a proprietary SIP header (X-ISDNTunnelingInfo) or a
dedicated message body (application/isdn) in the SIP messages
and sends the data as ISDN messages to the PSTN side.
This parameter is used for the ECT/TBCT/RLT/Path Replacement
ISDN Transfer methods. Usually, the device requests the PBX to
connect an incoming and outgoing call. This parameter determines
if the outgoing call (from the device to the PBX) must be connected
before the transfer is initiated.
[0] Alert = Enable ISDN Transfer if outgoing call is in Alert or
Connect state (default).
[1] Connect = Enable ISDN Transfer only if outgoing call is in
Connect state.
Determines (for IP-to-Tel calls) whether the Calling Number and
Calling Name IEs are removed from the ISDN SETUP message if
the presentation is set to Restricted.
[0] No = IE aren't removed (default).
[1] Yes = IE are removed.
Enables the device to remove the Calling Name from SIP-to-ISDN
calls.
[0] Disable = Does not remove Calling Name (default).
[1] Enable = Remove Calling Name.
Defines a single default ISDN release cause that is used (in ISDN-
to-IP calls) instead of all received release causes, except when the
following Q.931 cause values are received: Normal Call Clearing
(16), User Busy (17), No User Responding (18), or No Answer
from User (19).
The range is valid Q.931 release causes (0 to 127). The default
value is 0 (i.e., not configured - static mapping is used).
Defines a string prefix that is added to the Redirect number
received from the Tel side. This prefix is added to the Redirect
Number in the Diversion header.
The valid range is an 8-character string. The default is an empty
string.
239
3. Web-Based Management
Description
May 2008