System Parameters; Table 6-2: System Parameters - AudioCodes Mediant 1000 User Manual

6.5.2

System Parameters

ini File Field Name
Web Parameter Name
GroundKeyDetection
EnableDiagnostics
WatchDogStatus
LifeLineType
GWAppDelayTime
SIP User's Manual

Table 6-2: System Parameters

Valid Range and Description
Enables analog ground key detection (FXS and FXO modules implement
ground start signaling) per gateway. When disabled, the gateway uses
loop start signaling.
[0] = Disable (default)
[1]= Enable (enables ground start)
Notes:
For ground start signaling, ensure that the FXO G module is installed
(and not the regular FXO module) in the Mediant 1000.
For ground start FXO, the following parameters should be configured:
EnableCurrentDisconnect = 1; FXOBetweenRingTime = 300.
Checks the correct functionality of the different hardware components on
the gateway. On completion of the check, if the test fails, the gateway
sends information on the test results of each hardware component to the
Syslog server.
[0] = Rapid and Enhanced self-test mode (default).
[1] = Detailed self-test mode (full test of DSPs, PCM, Switch, LAN,
PHY and Flash).
[2] = A quicker version of the Detailed self-test mode (full test of
DSPs, PCM, Switch, LAN, PHY, but partial test of Flash).
For detailed information, refer to the SIP Series Reference Manual.
[0] = Disable gateway's watch dog.
[1] = Enable gateway's watch dog (default).
Defines the Lifeline phone type. The Lifeline phone is available on port 1
of each analog module.
The Lifeline is activated upon one of the following options:
[0] = Power down (default).
[1] = Power down or when link is down (physical disconnect).
[2] = Power down or when link is down or on network failure (logical
link disconnect).
Notes:
To enable Lifeline switching on network failure, LAN watch dog must
be activated (EnableLANWatchDog = 1).
This parameter is only applicable to FXS interface.
For a description of this parameter, refer to 'General Parameters' on
page 103.
308
Mediant 1000
Document #: LTRT-83302