Figure 3-72: Charge Codes Table - AudioCodes Mediant 1000 User Manual

SIP User's Manual
Parameter
Metering Tone Type
[MeteringType]
Charge Codes Table
3.4.5.2.4 Charge Codes Table
The 'Charge Codes Table' page is used to configure the metering tones (and their time
interval) that the FXS interfaces generate to the Tel side. To associate a charge code to an
outgoing Tel-to-IP call, use the 'Tel to IP Routing' table.
Notes:
To configure the Charge Codes table, take these 4 steps:
1. Access the 'Charge Codes Table' page (Configuration tab > Protocol Configuration
menu > SIP Advanced Parameters submenu > Charge Codes page item).
Alternatively, you can also access this page from the 'Metering Tones' page (refer to
''Metering Tones'' on page 182).
Version 5.4
Defines the metering tone (12 or 16 kHz) that is generated by FXS
interfaces.
[0] 12 kHz = 12-kHz metering tone (default).
[1] 16 kHz = 16-kHz metering tone.
Note: A suitable (12 or 16 KHz) FXS Coefficient file must be used for FXS
interfaces.
If you configured the 'Generate Metering Tones' parameter to 'Internal
Table', access the 'Charge Codes Table' page, by clicking
detailed information on configuring the Charge Codes table, refer to
''Charge Codes Table'' on page 183.
•
The 'Charge Codes Table' page is only available if the device provides
FXS interface (i.e., FXS module installed) and is applicable only to
Mediant 1000.
•
You can also configure the Charge Codes table using the ini file table
parameter ChargeCode (refer to ''Analog Telephony Parameters'' on
page 355).
Figure 3-72: Charge Codes Table Page
Description
183
3. Web-Based Management
. For
May 2008