Configuring The Web And Telnet Access List; Figure 3-58: Web & Telnet Access List Page - Add New Entry - AudioCodes Mediant 1000 User Manual

Notes:
3.4.4.2

Configuring the Web and Telnet Access List

The 'Web & Telnet Access List' page is used to define up to ten IP addresses that are
permitted to access the device's Web and Telnet interfaces. Access from an undefined IP
address is denied. If no IP addresses are defined, this security feature is inactive and the
device can be accessed from any IP address.
The Web and Telnet Access List can also be defined using the ini file parameter
WebAccessList_x (refer to ''Web and Telnet Parameters'' on page 311).
To add authorized IP addresses for Web and Telnet interfaces
access, take these 4 steps:
1. Open the 'Web & Telnet Access List' page (Configuration tab > Security Settings
menu > Web & Telnet Access List page item).
Figure 3-58: Web & Telnet Access List Page - Add New Entry
SIP User's Manual
•
For security, it's recommended that you change the default user name
and password used for initially accessing the Web interface.
•
The access level of the primary Web user account is 'Security
Administrator', which cannot be modified; all its' other account-attributes
can be modified.
•
A Web user with access level 'Security Administrator' can change all
attributes of all the Web user accounts. Web users with an access level
other than 'Security Administrator' can only change their own password
and user name.
•
To access the Web interface with a different account, click the Log off
button located on the toolbar, click any button or page item, and then re-
access the Web interface with a different user name and password.
•
You can set the entire Web interface to read-only (regardless of Web
user account's access level), by using the ini file parameter
DisableWebConfig (refer to ''Web and Telnet Parameters'' on page 311).
•
To reset the two Web user accounts' user names and passwords to
default, set the ini file parameter ResetWebPassword to 1.
•
Access to the Web interface can be disabled, by setting the ini file
parameter DisableWebTask to 1. By default, access is enabled.
•
You can define additional Web user accounts using a RADIUS server
(refer to the Product Reference Manual).
•
For secured HTTP connection (HTTPS) (refer to the Product Reference
Manual).
114
Mediant 1000 & Mediant 600
Document #: LTRT-83303