SIP User's Manual
To configure the IP to Trunk Group Routing table, take these 6
steps:
1.
Open the 'IP to Trunk Group Routing' page (Configuration tab > Protocol
Configuration menu > Routing Tables submenu > IP to Trunk Group Routing page
item).
2.
From the 'Routing Index' drop-down list, select the range of entries that you want to
add.
3.
From the 'IP to Tel Routing Mode' field, select the IP to Tel routing mode regarding
number manipulation (refer to the table below).
4.
Configure the table according to the table below.
5.
Click the Submit button to save your changes.
6.
To save the changes so they are available after a power failure, refer to ''Saving
Configuration'' on page 265.
Table 3-47: IP to Trunk Group Routing Table Description
Parameter
IP to Tel Routing Mode
[RouteModeIP2Tel]
Dest. Host Prefix
Version 5.4
Figure 3-78: IP to Trunk Group Routing Table Page
Determines whether to route IP calls to the Trunk group before or after
manipulation of destination number.
[0] Route calls before manipulation = IP-to-Tel calls are routed before
the number manipulation rules are applied (default).
[1] Route calls after manipulation = IP-to-Tel calls are routed after the
number manipulation rules are applied.
Note: To configure number manipulation, refer to ''Configuring the
Number Manipulation Tables'' on page 190.
The request URI host name prefix of the incoming INVITE message. If
configured, the device uses it for IP-to-Tel routing. If not used, it must be
left empty.
Note: The asterisk (*) symbol cannot be used to depict any destination
host prefix.
Description
205
3. Web-Based Management
May 2008