AudioCodes Mediant 1000 User Manual page 91

SIP User's Manual
Parameter
RTP Multiplexing Local UDP Port
[L1L1ComplexTxUDPPort]
RTP Multiplexing Remote UDP
Port
[L1L1ComplexRxUDPPort]
RTCP XR Settings
(Note: For a detailed description of RTCP XR reports, refer to the Product Reference Manual.)
Enable RTCP XR
[VQMonEnable]
RTCP XR Report Mode
[RTCPXRReportMode]
RTCP XR Packet Interval
[RTCPInterval]
Disable RTCP XR Interval
Randomization
[DisableRTCPRandomize]
RTCP XR Collection Server
[RTCPXREscIP]
Version 5.4
Determines the local UDP port used for outgoing multiplexed RTP
packets (applies to RTP multiplexing).
The valid range is the range of possible UDP ports: 6,000 to
64,000.
The default value is 0 (i.e., RTP multiplexing is disabled).
This parameter cannot be changed on-the-fly and requires a
device reset.
Determines the remote UDP port to where the multiplexed RTP
packets are sent, and the local UDP port used for incoming
multiplexed RTP packets (applies to RTP multiplexing).
The valid range is the range of possible UDP ports: 6,000 to
64,000.
The default value is 0 (i.e., RTP multiplexing is disabled).
This parameter cannot be changed on-the-fly and requires a
device reset.
Note: All devices that participate in the same RTP multiplexing
session must use this same port.
Enables voice quality monitoring and RTCP Extended Reports
(RTCP XR).
[0] Disable = Disable (default)
[1] Enable = Enables
Determines whether RTCP XR reports are sent to the Event State
Compositor (ESC), and if so, defines the interval in which they are
sent.
[0] Disable = RTCP XR reports are not sent to the ESC
(default).
[1] End Call = RTCP XR reports are sent to the ESC at the end
of each call.
[2] End Call & Periodic = RTCP XR reports are sent to the ESC
at the end of each call and periodically according to the
parameter RTCPInterval.
Defines the time interval (in msec) between adjacent RTCP
reports.
The interval range is 0 to 65,535. The default interval is 5,000.
Controls whether RTCP report intervals are randomized or whether
each report interval accords exactly to the parameter
RTCPInterval.
[0] Disable = Randomize (default)
[1] Enable = No Randomize
IP address of the Event State Compositor (ESC). The device
sends RTCP XR reports to this server, using PUBLISH messages.
The address can be configured as a numerical IP address or as a
domain name.
91
3. Web-Based Management
Description
May 2008