Figure 3-9: Editing Symbol After Modifying Parameter Value; Figure 3-10: Value Reverts To Previous Valid Value - AudioCodes Mediant 1000 User Manual

SIP User's Manual

Figure 3-9: Editing Symbol after Modifying Parameter Value

To save configuration changes on a page to the device's volatile
memory (RAM), take this step:
Click the Submit
you are working; modifications to parameters with on-the-fly capabilities are
immediately applied to the device and take effect; other parameters (displayed on the
page with the lightning
reset (refer to ''Resetting the Device'' on page 262) before taking effect.
Note:
If you enter an invalid parameter value (e.g., not in the range of permitted values) and then
click Submit, a message box appears notifying you of the invalid value. In addition, the
parameter value reverts to its previous value and is highlighted in red, as shown in the
figure below:
Version 5.4
button, which is located near the bottom of the page in which
symbol) are not changeable on-the-fly and require a device
Parameters saved to the volatile memory (by clicking Submit), revert to their
previous settings after a hardware or software reset (or if the device is
powered down). Therefore, to ensure parameter changes (whether on-the-fly
or not) are retained, you need to save ('burn') them to the device's non-
volatile memory, i.e., flash (refer to ''Saving Configuration'' on page 265).

Figure 3-10: Value Reverts to Previous Valid Value

35
3. Web-Based Management
May 2008