AudioCodes Mediant 1000 User Manual page 365

SIP User's Manual
ini File Parameter
DefaultNumber
ChannelSelectMode
TrunkGroupSettings
AddTrunkGroupAsPrefix
AddPortAsPrefix
ReplaceEmptyDstWithPort
Number
Version 5.4
For a description of this parameter, refer to ''DTMF & Dialing
Parameters'' on page 160.
For a description of this parameter, refer to ''SIP General Parameters''
on page 134.
This ini file table parameter defines rules for port allocation per Trunk
Group. If no rule exists, the global rule defined by the parameter
ChannelSelectMode takes effect. The format of this parameter is as
follows:
[TrunkGroupSettings]
FORMAT TrunkGroupSettings_Index =
TrunkGroupSettings_TrunkGroupId,
TrunkGroupSettings_ChannelSelectMode,
TrunkGroupSettings_RegistrationMode,
TrunkGroupSettings_GatewayName,TrunkGroupSettings_ContactUse
r, TrunkGroupSettings_ServingIPGroup;
[\TrunkGroupSettings]
Where,
TrunkGroupId = Trunk Group ID number.
ChannelSelectMode = Channel select mode for the Trunk Group.
Available values are identical to those defined by the
ChannelSelectMode parameter.
RegistrationMode = Registration mode for the Trunk Group (Per
Endpoint [0], Per Gateway [1], or Do Not Register [4]). If not
configured [-1], the value of AuthenticationMode is used.
GatewayName = SIPGatewayName used as a hostname in the From
header in INVITE and REGISTER messages. If not configured, the
parameter SIPGatewayName is used.
ContactUser = User part in contact URI in INVITE, and in From, To
and Contact headers in REGISTER.
ServingIPGroup = Serving IP Group ID to where INVITE messages
initiated by the Trunk Group endpoints are sent.
For example:
[TrunkGroupSettings]
TrunkGroupSettings 0 = 1, 0, 5, audiocodes, user, 1;
TrunkGroupSettings 1 = 2, 1, 0, localname, user1, 2;
[\TrunkGroupSettings]
Notes:
This parameter can include up to 240 indices.
For configuring Trunk Group Settings using the Web interface, refer
to ''Configuring Trunk Group Settings'' on page 228.
For a description on using ini file table parameters, refer to ''Structure
of ini File Table Parameters'' on page 293.
For a description of this parameter, refer to ''Routing General
Parameters'' on page 198.
For a description of this parameter, refer to ''Routing General
Parameters'' on page 198.
For a description of this parameter, refer to Routing General Parameters
on page 198.
365
4. ini File Configuration
Description
May 2008