AudioCodes Mediant 1000 User Manual page 350

ini File Parameter
SITQ850Cause
UserToUserHeaderForm
at
RemoveCLIWhenRestric
ted
ScreeningInd2ISDN
ProgressIndicator2ISDN
_ID
PIForDisconnectMsg_ID For a description of this parameter, refer to ''Configuring the Trunk
ConnectOnProgressInd Enables the play of announcements from IP to PSTN without the need to
SIP183Behaviour
LocalISDNRBSource_ID For a description of this parameter, refer to ''Configuring the Trunk
PSTNAlertTimeout
TrunkPSTNAlertTimeout
_ID
ISDNTransferCapability_
ID
BChannelNegotiationFor
Trunk_ID
SendISDNTransferOnCo
nnect
SIP User's Manual
Determines the Q.850 cause value specified in the Reason header that is
included in a 4xx response when Special Information Tone (SIT) is
detected on an IP-to-Tel call.
The valid range is 0 to 127. The default value is 34.
Determines the format of the User-to-User header.
[0] = X-UserToUser (default)
[1] = User-to-User
For a description of this parameter, refer to ''Configuring the Digital
Gateway Parameters'' on page 235.
For a description of this parameter, refer to ''Configuring the Digital
Gateway Parameters'' on page 235.
For a description of this parameter, refer to ''Configuring the Trunk
Settings'' on page 96.
Settings'' on page 96.
answer the Tel-to-IP call. It can be used with PSTN networks that don't
support the opening of a TDM channel before an ISDN Connect message
is received.
[0] = Connect message isn't sent after SIP 183 Session Progress
message is received (default).
[1] = Connect message is sent after SIP 183 Session Progress
message is received.
For a description of this parameter, refer to ''SIP General Parameters'' on
page 134.
Settings'' on page 96.
For a description of this parameter, refer to ''Advanced Parameters'' on
page 166.
For a description of this parameter, refer to ''Configuring the Trunk
Settings'' on page 96.
For a description of this parameter, refer to ''Configuring the Trunk
Settings'' on page 96.
For a description of this parameter, refer to ''Configuring the Trunk
Settings'' on page 96.
For a description of this parameter, refer to ''Configuring the Digital
Gateway Parameters'' on page 235.
350
Mediant 1000 & Mediant 600
Description
Document #: LTRT-83303