AudioCodes Mediant 1000 User Manual page 369

SIP User's Manual
ini File Parameter
SwapTel2IPCalled&Calling
Numbers
AddTON2RPI
NumberMapTel2IP
Version 5.4
If enabled, the device swaps the calling and called numbers received
from the Tel side. The INVITE message contains the swapped numbers.
Applicable for Tel-to-IP calls.
[0] = Disabled (default)
[1] = Swap calling and called numbers
For a description of this parameter, refer to ''SIP General Parameters''
on page 134.
This ini file table parameter manipulates manipulates the destination
number of Tel-to-IP calls. The format of this parameter is as follows:
[NumberMapTel2Ip]
FORMAT NumberMapTel2Ip_Index =
NumberMapTel2Ip_DestinationPrefix,
NumberMapTel2Ip_SourcePrefix,
NumberMapTel2Ip_SourceAddress, NumberMapTel2Ip_NumberType,
NumberMapTel2Ip_NumberPlan,
NumberMapTel2Ip_RemoveFromLeft,
NumberMapTel2Ip_RemoveFromRight,
NumberMapTel2Ip_LeaveFromRight, NumberMapTel2Ip_Prefix2Add,
NumberMapTel2Ip_Suffix2Add,
NumberMapTel2Ip_IsPresentationRestricted;
[\NumberMapTel2Ip]
Where,
DestinationPrefix = Destination number prefix.
SourcePrefix = Source number prefix.
SourceAddress = N/A.
NumberType = Number Type used in RPID header.
NumberPlan = Number Type used in RPID header.
RemoveFromLeft = Number of stripped digits from the left.
RemoveFromRight = Number of stripped digits from the right.
LeaveFromRight = Number of remaining digits from the right.
Prefix2Add = String to add as prefix.
Suffix2Add = String to add as suffix.
IsPresentationRestricted = N/A (set to $$).
For example:
[NumberMapTel2Ip]
NumberMapTel2Ip 0 = 01,$$,*,0,0,2,$$,$$,971,$$,$$;
NumberMapTel2Ip 1 = 10,10,*,255,255,3,0,5,100,$$,255;
[\NumberMapTel2Ip]
Notes:
RemoveFromLeft, RemoveFromRight, Prefix2Add, Suffix2Add,
LeaveFromRight, NumberType, and NumberPlan are applied if the
called and calling numbers match the DestinationPrefix and
SourcePrefix conditions.
The manipulation rules are executed in the following order:
RemoveFromLeft, RemoveFromRight, LeaveFromRight, Prefix2Add,
and Suffix2Add.
Parameters can be skipped by using two dollar signs ('$$').
Number Plan and Type can optionally be used in Remote Party ID
369
4. ini File Configuration
Description
May 2008