AudioCodes Mediant 1000 User Manual page 358

ini File Parameter
FwdInfo
EnableCallerID
SIP User's Manual
This ini file table parameter forwards IP-to-Tel calls (using SIP 302
response), based on the device's port to which the call is routed.
The format of this parameter is as follows:
[FwdInfo]
FORMAT FwdInfo_Index = FwdInfo_Type, FwdInfo_Destination,
FwdInfo_NoReplyTime, FwdInfo_Port, FwdInfo_Module;
[\FwdInfo]
Where,
Type = Forward Type (for a list of options, refer to ''Call Forward'' on
page 222).
Destination = Telephone number or URI (number@IP address) to which
the call is forwarded.
NoReplyTime = Timeout (in seconds) for No Reply. If you have set the
Forward Type for this port to No Answer [3], enter the number of
seconds the device waits before forwarding the call to the phone
number specified.
Port = Port number.
Module = Module number (0 - 5).
For example:
[FwdInfo]
FwdInfo 1 = 1,1001,$$,2,0;
FwdInfo 2 = 1,2003@10.5.1.1,$$,2,0;
FwdInfo 3 = 3,2005,30,2,0;
[\FwdInfo]
Notes:
The indexing of this parameter starts at 1.
The device ports starts at 0.
To configure the Call Forward table using the Web interface, refer to
''Call Forward'' on page 222.
For an explanation on ini file table parameters, refer to ''Structure of ini
File Table Parameters'' on page 293.
This ini file table parameter configures Caller ID permissions. The format of
this parameter is as follows:
[EnableCallerID]
FORMAT EnableCallerID_Index = EnableCallerID_IsEnabled,
EnableCallerID_Port, EnableCallerID_Module;
[\EnableCallerID]
Where,
IsEnabled = Enables [1] or disables [0] (default) Caller ID.
Port = Port number.
Module = Module number (0-5).
For example:
[EnableCallerID]
EnableCallerID 1 = 1,3,2;
EnableCallerID 2 = 0,$$,$$;
[\EnableCallerID]
Notes:
The indexing of this ini file table parameter starts at 1.
358
Mediant 1000 & Mediant 600
Description
Document #: LTRT-83303