AudioCodes Mediant 1000 User Manual page 168

Parameter
Enable Digit Delivery to Tel
[EnableDigitDelivery]
RTP Only Mode
[RTPOnlyMode]
SIP User's Manual
Enables the Digit Delivery feature, which sends DTMF digits (of the
called number) to the device's port (phone line) after the call is answered
[line offhooked (FXS) or seized (FXO)] for IP-to-Tel calls.
[0] Disable = Disabled (default).
[1] Enable = Enable Digit Delivery feature for the FXO/FXS device.
For digital modules: If the called number in IP-to-Tel call includes the
characters 'w' or 'p', the device places a call with the first part of the
called number (before 'w' or 'p') , and plays DTMF digits after the call is
answered. If the character 'w' is used, the device waits for detection of
dial tone before it starts playing DTMF digits. For example, if the called
number is '1007766p100', the device places a call with 1007766 as the
destination number, then after the call is answered, it waits 1.5 seconds
('p') and plays the rest of the number (100) as DTMF digits.
Additional examples: 1664wpp102, 66644ppp503, and 7774w100pp200.
Notes for Mediant 1000 analog interfaces:
The called number can include characters 'p' (1.5 seconds pause)
and 'd' (detection of dial tone). If character 'd' is used, it must be the
first 'digit' in the called number. The character 'p' can be used several
times.
For example (for FXS/FXO interfaces), the called number can be as
follows: d1005, dpp699, p9p300. To add the 'd' and 'p' digits, use the
usual number manipulation rules.
To use this feature with FXO interfaces, configure the device to
operate in one-stage dialing mode.
If this parameter is enabled, it is possible to configure the FXS/FXO
interface to wait for dial tone per destination phone number (before or
during dialing of destination phone number). Therefore, the parameter
IsWaitForDialTone (configurable for the entire device) is ignored.
The FXS interface send SIP 200 OK responses only after the DTMF
dialing is complete.
Enables the device to start sending and/or receiving RTP packets to and
from remote endpoints without the need to establish a Control session.
The remote IP address is determined according to the 'Tel to IP Routing'
table (refer to ''Tel to IP Routing Table'' on page 200). The port is the
same port as the local RTP port (set by BaseUDPPort and the channel
on which the call is received).
[0] Disable = Disable (default).
[1] Transmit & Receive = Send and receive RTP.
[2] Transmit Only= Send RTP only.
[3] Receive Only= Receive RTP only.
Notes:
To configure the RTP Only mode per trunk, use the
RTPOnlyModeForTrunk_ID (refer to "Configuring the Trunk Settings"
on page 96).
If per trunk configuration (using RTPOnlyModeForTrunk) is set to
other than default, the RTPOnlyMode parameter value is overridden.
168
Mediant 1000 & Mediant 600
Description
Document #: LTRT-83303