Table 3-28: Ipsec Spd Table Configuration Parameters - AudioCodes Mediant 1000 User Manual

Table 3-28: IPSec SPD Table Configuration Parameters

Parameter Name
IPSec Mode
[IPSecMode]
Remote Tunnel IP Address
[IPSecPolicyRemoteTunne
lIPAddress]
Remote Subnet Mask
[IPsecPolicyRemoteSubne
tMask]
Remote IP Address
[IPSecPolicyRemoteIPAdd
ress]
Local IP Address Type
[IPSecPolicyLocalIPAddre
ssType]
Source Port
[IPSecPolicySrcPort]
Destination Port
[IPSecPolicyDstPort]
Protocol
[IPSecPolicyProtocol]
Related Key Exchange
Method Index
[IPsecPolicyKeyExchange
MethodIndex]
SIP User's Manual
Defines the IPSec mode of operation.
[0] Transport (Default)
[1] Tunneling
Defines the IP address of the remote IPSec
tunneling device.
Note: This parameter is only available if the
parameter IPSecMode is set to Tunneling (1).
Defines the subnet mask of the remote IPSec
tunneling device.
The default value is 255.255.255.255 (i.e., host-to-
host IPSec tunnel).
Note: This parameter is only available if the
parameter IPSecMode is set to Tunneling (1).
Destination IP address (or FQDN) to which the
IPSec mechanism is applied.
Notes:
This parameter is mandatory.
When an FQDN is used, a DNS server must be
configured (DNSPriServerIP).
Determines the local interface to which the
encryption is applied (applicable to multiple IPs
and VLANs).
[0] OAM = OAMP interface (default).
[1] Control = Control interface.
Defines the source port to which the IPSec
mechanism is applied.
The default value is 0 (i.e., any port).
Defines the destination port to which the IPSec
mechanism is applied.
The default value is 0 (i.e., any port).
Defines the protocol type to which the IPSec
mechanism is applied.
0 = Any protocol (default).
17 = UDP.
6 = TCP.
Any other protocol type defined by IANA
(Internet Assigned Numbers Authority).
Determines the index for the corresponding IKE entry. Note that several
policies can be associated with a single IKE entry.
The valid range is 0 to 19. The default value is 0.
128
Mediant 1000 & Mediant 600
Description
IPSec is applied to
outgoing packets
whose IP address,
destination port,
source port, and
protocol type match
the values defined
for these
parameters.
Document #: LTRT-83303