Integrating Using The Web Interface; Figure 8-2: Vlan Configuration In The Ip Settings; Table 8-2: Example Of Vlan And Multiple Ips Configuration - AudioCodes Mediant 1000 User Manual

Table 8-2: Example of VLAN and Multiple IPs Configuration

Network
IP Address Subnet Mask
Type
OAMP 10.31.174.50
Control 10.32.174.50
Media 10.33.174.50
Notes:
8.9.3.1

Integrating Using the Web Interface

The procedure below describes how to integrate the device into a multiple IPs network
withVLANs, using the Web interface.
To integrate the device into a multiple IPs network withVLANs
using the Web interface, take these 6 steps:
1. Access the Web interface (refer to ''Accessing the Web Interface'' on page 26).
2. Use the Software Upgrade Wizard (refer to ''Software Upgrade Wizard'' on page 272)
to load and burn the firmware version to the device (VLANs and multiple IPs support is
available only when the firmware is burned to flash).
3. Configure the VLAN parameters by completing the following steps:
a. Open the 'IP Settings' page (refer to ''Configuring the IP Settings'' on page 64).
b. Modify the VLAN parameters to correspond to the values shown in the following
figure:
Figure 8-2: VLAN Configuration in the IP Settings Page
c. Click the Submit button to save your changes.
SIP User's Manual
Default Gateway
255.255.0.0
255.255.0.0
255.255.0.0
•
The values provided in this section are only used as an example.
•
Since a default Gateway is available only for the Media network, for the
device to be able to communicate with an external device/network on its
OAMP and Control networks, IP routing rules must be used.
VLAN ID
IP Address
0.0.0.0
0.0.0.0
10.33.0.1
454
Mediant 1000 & Mediant 600
External Routing
Rule
4 83.4.87.X
5 130.33.4.6
6 --
Document #: LTRT-83303