AudioCodes Mediant 1000 User Manual page 361

SIP User's Manual
ini File Parameter
BlindTransferDisconne
ctTimeout
RejectAnonymousCallP
erPort
IsTwoStageDial
IsWaitForDialTone
FXOBetweenRingTime For a description of this parameter, refer to ''Configuring the FXO
RingsBeforeCallerID
DisconnectOnDialTone For a description of this parameter, refer to ''Configuring the FXO
GuardTimeBetweenCall
s
Version 5.4
Defines the duration (in milliseconds) for which the device waits for a
disconnection from the Tel side after the Blind Transfer Code
(KeyBlindTransfer) has been identified. When this timer expires, a SIP
REFER message is sent toward the IP side. If this parameter is set to 0,
the REFER message is immediately sent.
The valid range is 0 to 1,000,000. The default is 0.
Note: This parameter is applicable only to Mediant 1000.
This ini file table parameter determines whether the device rejects
incoming anonymous calls on FXS interfaces. The format of this parameter
is as follows:
[RejectAnonymousCallPerPort]
FORMAT RejectAnonymousCallPerPort_Index =
RejectAnonymousCallPerPort_Enable, RejectAnonymousCallPerPort_Port,
RejectAnonymousCallPerPort_Module;
[\RejectAnonymousCallPerPort]
Where,
Enable = accept [0] (default) or reject [1] incoming anonymous calls.
Port = Port number.
Module = Module number.
For example:
[RejectAnonymousCallPerPort]
RejectAnonymousCallPerPort 0 = 0,1,$$;
RejectAnonymousCallPerPort 1 = 1,2,$$;
[\RejectAnonymousCallPerPort]
If enabled, when a device's FXS interface receives an anonymous call, it
responds with a 433 (Anonymity Disallowed) SIP response.
Notes:
This parameter is applicable only to FXS interfaces.
This parameter is per FXS port.
This parameter can appear up to 24 times.
The double dollar ($$) symbol represents the default value.
For an explanation on using ini file table parameters, refer to ''Structure
of ini File Table Parameters'' on page 293.
For a description of this parameter, refer to ''Configuring the FXO
Parameters'' on page 248.
For a description of this parameter, refer to ''Configuring the FXO
Parameters'' on page 248.
Parameters'' on page 248.
For a description of this parameter, refer to ''Configuring the FXO
Parameters'' on page 248.
Parameters'' on page 248.
For a description of this parameter, refer to ''Configuring the FXO
Parameters'' on page 248.
Description
361
4. ini File Configuration
May 2008