Adjusting The Label Rest Point - Intermec 4630 User Manual

4630 and 4830 Bar Code Label Printers User's Manual

Adjusting the Label Rest Point

2-12
To adjust the print alignment
1. From the ONLINE READY display, press Menu to enter the Operator
menu.
2. Press ↑ or ↓ until the display shows:
OPERATOR MENU
X FORMS ADJUST
3. Press Select. The display shows the current X Forms Adjust command
setting.
4. Press ↑ to increase the number and move the print towards the back of the
label. Press ↓ to decrease the number and move the print towards the front
of the label.
Note: The range of the X Forms Adjust command is from -30 (furthest forward on
the label) to +30 (furthest backward on the label). The range for the Y Forms
Adjust command is from -30 (closest to the top of the label) to +30 (closest to the
bottom of the label).
5. Press Enter at the setting you want.
6. Press Cont to return to the ONLINE READY display.
7. Print several labels. If the print is not positioned properly, repeat this
procedure until you get the results you want.
The Label Rest Point command sets the point where labels are presented for
cutting or removal from the printer. This command is primarily used with the
self-strip and cutter options. Adjust the label rest point setting, if you are
loosing part of a label each time one is cut or removed from the printer.
To adjust the label rest point
1. From the ONLINE READY display, press Menu to enter the Operator
menu.
2. Press ↑ or ↓ until the display shows:
OPERATOR MENU
LABEL REST POINT
3. Press Select. The display shows the current setting for the Label Rest Point
command.