Memory Reset; Lss Test; Media; Media Type - Intermec EasyCoder PX4i User Manual

Media

EasyCoder PX4i User's Guide (IPL Version)

Memory Reset

There are two options. The memory will be reset to factory
default as soon as an option has been selected and <Enter> is
pressed. Select between "All", which resets the entire memory,
and "Configuration", which just resets the configuration part of
the memory.

LSS Test

"Label Stop Sensor" on page
For description, see
The media parameters tell the firmware the characteristics of the
media that will be used, so the printout will be positioned
correctly and get the best quality possible.

Media Type

The Media Type parameters control how the label stop sensor
(LSS) and the media feed work. There are three media type
options:
• Gap is used for adhesive labels mounted on liner (backing
paper) or continuous paper stock with detection slots.
Default.
• Mark is used for labels, tickets, or strip provided with black
marks at the back.
• Continuous is used for continuous stock without any
detection slots or black marks.

Paper Type

The Paper Type parameters control how the transfer ribbon
mechanism and the ribbon sensor work. There are two paper
type options:
• DT (Direct Thermal) is used for heat-sensitive media without
any need for a thermal transfer ribbon. Default.
• TTR (Thermal Transfer) is used for non heat-sensitive
receiving face materials in combination with a thermal
transfer ribbon.

Label Length Dots

The Label Length setup specifies the length in dots of each copy
along the media feed direction (X-coordinate). This is used for
"label-out" detection.
Chapter 6 — Setting Up the Printer
106.
65