Memory Cards; Power On - Intermec EasyCoder 501 XP Installation & Operation Manual

Memory Card

Power On

Intermec EasyCoder 501 XP – Installation & Operation Ed. 4
If you want to use a memory card, you must insert it into the slot in
the printer's rear plate before you turn on the power. The memory
card can be an SRAM card complying with the JEIDA-4 standard
or Flash Memory card from Intermec. There are three types of
Flash Memory Cards:
• A Font Card provides additional fonts as long as it remains
inserted in the printer.
• A Font Install Card permanently installs additional fonts in
the printer which can be used even after the card has been
removed.
• A Firmware Card automatically replaces the printer's fi rmware,
e.g. with an updated version.
Important!
Always turn off the power before inserting or removing a memory
card!
Do not start the printer before you have made the necessary
connections, inserted any memory card you want to use, and
checked that the printhead is lowered and the optional cutter is
in closed position.
Turn on the power by means of the main switch on the rear plate.
The "Power" LED control lamp on the front panel lights up when
the power is on. Wait for a few moments, while the printer loads
the program and runs some self-diagnostic tests. If the printer is
fi tted with a paper cutter, it will rotate to home position. Finally,
some kind of message will appear in the display window, depending
on startup fi le.
Chapter 4 Starting Up
Memory Card
25