Media Load - Peel-Off (Self-Strip) - Intermec EasyCoder E4 User Manual

Media Load – Peel-Off (Self-strip)
1
1
Open the side and front covers.
Intermec EasyCoder E4 – User's Guide
This section describes the case when self-adhesive labels are sepa-
rated from the liner immediately after printing. The liner is then
wound up on an integral liner takeup hub. This is also known
as "Self-strip" operation. It cannot be with on the EasyCoder E4
LinerLess printer
Before shipping the printer, always remove any roll from the
HINT!
To facilitate media and ribbon load, you can remove the side cover
by opening it halfway (45°) and lift the hinges out of their pockets
in the bottom moulding.
2
Caution!
media supply roll post.
2
Turn the printhead lift lever counterclockwise to
raise the printhead.
Chapter 3 Operation
15