Peel-Off (Self-Strip) - Intermec EasyCoder F2 User Manual

Peel-Off (Self-strip)

Important!
Save the label indicating the
sensitivity number attached to
the media roll. You will need
this number to set the media
sensitivity, see Appendix 2.
1
Open the side door.
Intermec EasyCoder F2 – User's Guide
The EasyCoder F2 can print on labels, tickets, tags, and continu-
ous stock in various forms. This section describes the case when
self-adhesive labels are separated from the liner immediately after
printing. The liner is then wound up on an integral liner takeup
hub. This is also known as "Self-strip" operation.
Peel-off operation cannot be performed when Quick-Load guides
are fi tted.
Peel-off can only be used for:
• Self-adhesive labels with liner
An optional label-taken sensor can hold the printing of the next
label in a batch until the present label has been removed, see
Chapter 8, "Options."
2
Turn the printhead lift lever clockwise to raise
Chapter 4 Media Load
the printhead.
25