Adding New Hardware To Avaya™ Mcc1, Scc1, And G600 Media Gateways - Avaya MCC1 Hardware Manual

Adding New Hardware to
Avaya™ MCC1, SCC1, and
G600 Media Gateways
This section provides information on adding hardware to Avaya™ MCC1, SCC1, and G600
Media Gateways used with an Avaya™ S8700 Media Server. To install adjunct or peripheral
equipment, refer to Installation for Adjuncts and Peripherals for Avaya™ Communication
Manager.
NOTE:
If a circuit pack requires a right-to-use fee for a particular feature, then the customer must
have a license file to enable the feature.
When installing additional features or equipment, it may be necessary to install additional
circuit packs. This is a general procedure to use when adding features or equipment that require
adding circuit packs.
NOTE:
You must log into the active media server to access SAT commands. Use a terminal
emulation application, such as Avaya™ Terminal Emulation, or Avaya™ Site
Administration.
1 Log into the media server using a services log in.
Install the TN circuit pack into the media gateway or carrier (if MCC1).
2
Do the minimally required administration so that Avaya™ Communication Manager
3
recognizes the circuit pack.
Log off the media server after the addition and any required administration is complete.
4
For information about administering circuit packs and other equipment, refer to the
Administrator's Guide for the Avaya™ Communication Manager.
Adding New Hardware to Avaya™ MCC1, SCC1, and G600 Media Gateways
May 2003
7