Setting The Carrier Address Id - Avaya G650 Installing

Setting the carrier address ID

Set the carrier address ID either before or after you install each G650 Media Gateway. To set
the carrier address, insert the address paddleboard in one of five connector slots on the
upper-right side of the backplane. The slots are marked as A, B, C, D, and E. Avaya ships all
carriers with the address paddleboard in connector slot A. If you are working on a B, C, D, or E
carrier, you must remove the address paddleboard. Then move the paddleboard to the correct
slot for a B, C, D, or E carrier.
To set the carrier address ID:
1. Loosen the thumb screws on the fan assembly and pull the assembly straight out
(Figure 3: Removing the fan assembly
connection. Place the assembly on top of the cabinet or hang the assembly from the rear
connector panel with the screws on the back of the assembly. Leave the fan assembly off
until the unit is completely installed in the rack.
2. Verify and, if necessary, set the carrier address ID for each G650 Media Gateway
(Figure 4: Setting the carrier address ID on the G650 Media Gateway
the address paddleboard in the connector slot that you want, either slot A, B, C, D, or E.
Figure 3: Removing the fan assembly
fndprem2 LAO 071503
Installing the G650 Media Gateway
on page 21). You do not need to unplug the
on page 22). Place
Issue 2 February 2007 21