Using The Book Scanner; Using The Single Feed Tray; Figure 1-20 Using The Book Scanner - NEC IT3510 Operation Manual

Issue 1
5.2
5.3
1 - 26

Using the Book Scanner

1. Open the Document Cover and place the document face down and flush
with the glass surface.
2. Position the document in the top right-hand corner of the glass surface.
3. For transmission, the document should be placed with its longer side
against the back edge of the glass surface. If placed with the shorter side
against the back, the entire document may be reduced when transmitted.
4. When [Book] on the [Orig.
document to the mark on the Book Scanner.
5. Close the Document cover before beginning transmission or copying.

Figure 1-20 Using the Book Scanner

Using the Single Feed Tray

1. Open the Single Feed Tray.
2. Adjust the document guide to the width of the document.
3. Check that the green lamp on the <Start> key is lit.
4. Insert the document face down, so that it is flush with the edge of the
guide.
Copy] is used, adjust the center of the
Bookscanner mark
Place the book, magazine, etc.
in the top right-hand corner
NEC IT Series
Getting Started