NEC IT3510 Operation Manual page 435

NEC IT Series
NEC IT3510/IT2510 Operations Manual
Print Paper Jam
Use the following procedures to remove jammed print paper.
Before Starting Operations:
If print paper becomes jammed, the touch panel displays a message "A document is
jammed. Remove the document from
opened. Open the cover indicated by an arrow, and remove the jammed paper.
If the Print Paper Frequently Jams:
Confirm how to install the print paper, storage conditions, and the print paper size, etc.
Refer to Section 9.1 Installing Print Paper in Chapter 1 Getting Started on page 1-37.
If the multi-purpose or universal cassettes are used, the print paper will become
jammed if the paper size is incorrectly set.
If the Side Cover is Opened to Remove Jammed Paper:
Care should be taken if the imaging unit is needed to be withdrawn in order to remove
jammed paper. A toner spill may occur. Toner may ruin the working surface or your
clothes.
Caution!
Do not touch the copper terminals located
within the Side Cover, under the imaging
unit.
Doing so may cause failure due to static
discharge.
Displays and Paper Jam Positions
The handling procedure differs according to the position of the paper jam. Refer
to the appropriate page indicated for instructions on removing the jammed paper.
3rd Tray
see page 8-25
Staple Cartridge
(see Chapter 1,
page 1-62)
Finisher/Mail-bin
Finisher
)
(see page 8-18
Job Tray/Shift Tray
(see page 8-16
." , and indicates which cover needs to be
Side Cover
) (see page 8-12
Issue 1
2-Sided Document
Feeder
)
(see page 8-8
Automatic Document
Feeder
)
(see page 8-6
2-Sided Print Unit
)
(see page 8-17
Fuser Unit Cover
)
(see page 8-15
)
8 - 11