Selecting The Copy Paper Size For Copying - NEC IT3510 Operation Manual

Issue 1
1.4
2 - 6

Selecting the Copy Paper Size for Copying

When two or more sizes of paper are installed, the print paper size selection
can be set automatically in accordance with the scanned document. Manual
paper size selection is available, as well.
Before Starting Operations:
The machine automatically reduces or enlarges the copied image in accordance with
the print paper size if [Auto Size] is selected as the zoom ratio. For details on
enlargement and reduction, refer to
on page 2-13
.
Automatic Paper Selection Function:
This function automatically selects the paper in accordance with the scanned
document's size, direction, and zoom ratio setting.
The Automatic Paper Selection function has a preset (default) factory setting. It can
be set to select a determined copy paper cassette as priority. For details, refer to
Section
2.4 Copy Settings in Chapter 4 on page 4-19.
If an irregularly sized document is set (any size other than letter or legal size), the
document size may not be detected correctly, and may be copied on the incorrect size
paper or not copied at all. In this case, the operator must manually select the copy
paper cassette.
When the ADF is used for copying, the copy size will be determined by the first
scanned page of the document and the same sized paper will be used for the
remaining printed pages. (This does not apply to a case when the 'Mixed Original
Detection' setting has been enabled.)
When letter sized paper is selected for copying, even if the document and paper
direction differ, the direction of the paper can automatically be rotated 90
(This function cannot be used when the Book Scanner is used for copying after
selecting the paper.)
Selecting the Copy Paper Cassette
1.
Load the document in the ADF
or Book Scanner.
For more information, refer to
Section 5 Handling Documents in
Chapter 1 on page 1-25.
2.
Press <COPY>.
1.6 Selecting the Zoom Ratio for Copying
Section
NEC IT Series
o
for copying.
Copy Operations