Quitting An Operation; Figure 1-23 Pressing The Stop Key - NEC IT3510 Operation Manual

Issue 1
S 6 Q
ECTION UITTING AN
This section describes how to quit an operation in progress.
Press the <Stop> Key
1 - 30
Transmitting Ledger sized Documents
When a Ledger (11" by 17") document is transmitted, it is automatically
Ë
reduced according to the paper sizes available in the receiving facsimile.
To send Ledger size pages in their original size, select Nonreduced
Transmission. For additional details, refer to 2.11 Sending Documents
without Reduction in Chapter 5 Basic Sending and Receiving Operations
.
on page 5-15
Original (sender's) paper size
Destination unit's paper sizes
Ledger (11" by 17")
Legal
Letter
O
PERATION

Figure 1-23 Pressing the Stop Key

Press the <Stop> key when setting functions or registering information.
Ë
When the machine is operating, the function that is currently being used
is displayed on the touch panel, so that key may be touched to stop that
particular function. If either <Stop> or [Cancel] is pressed once again
without selecting the function to be canceled, the operation returns to the
original status.
Ledger (11"x17") Legal (8.5"x14")
Original size Original size
Reduced to legal Original size
Reduced to letter Reduced to letter
NEC IT Series
Getting Started