Making And Receiving Telephone Calls - NEC IT3510 Operation Manual

NEC IT Series
3.6
NEC IT3510/IT2510 Operations Manual
If the received document is too long to be printed on the installed print
Ë
paper (even to the maximum reduction amount of 60%), the image is
divided and printed on multiple pages. In this case, the transition area
(the area where the image is divided) is printed on both pages.
The maximum reduction ratio can be set. The "Cut Off" mode is also
available, in which case the excess area is ignored when printed.
For more details, refer to Section 2.10 Settings for Received Documents
in Chapter 3 Registration and Setting Operations on page 3-27.

Making and Receiving Telephone Calls

The NEC IT3510/IT2510 can be used to make voice calls in addition to
facsimiles. This section describes the method of using a telephone connected
to the unit.
Before Starting Operations:
An external telephone (not provided) must be connected to the jack marked 'TEL' on
the back of the unit.
Tone dialing is available even if the telephone line is a for Dial Pulse. Touch [Tone] to
send dialing tones after calling the destination.
Making a Call:
1.
Press <FAX/MAIL>.
Issue 1
5 - 27