Using The Tx Marker - NEC IT3510 Operation Manual

NEC IT Series
2.10
NEC IT3510/IT2510 Operations Manual

Using the TX Marker

The TX Marker feature stamps a small red circle at either the bottom, or the
top and bottom of each scanned page. This confirms to the user that a page
was successfully scanned into memory.
Before Starting Operations:
An optional TX Marker is required for this function.
Replace the TX Marker when the print becomes too light. Refer to Section 9.4
Installing and Replacing the Transmission (TX) Marker Stamp in Chapter 1 Getting
Started on page 1-59.
The TX Marker cannot be used with the copy features.
The TX Marker can not be used in conjunction with the optional 2-Sided Document
Feeder.
Using the TX Marker
1.
Load the document in the ADF.
Refer to Section 5 Handling
Documents in Chapter 1 Getting
Started on page 1-25.
2.
Press <FAX/MAIL>.
3.
Select [Set 1] from [FAX Menu],
then touch [TX Marker].
4.
Select the desired stamping
position, then touch [Enter].
5.
Select the destination.
Issue 1
6 - 19