Installing And Replacing The Transmission (Tx) Marker Stamp; Figure 1-71 Closing The Toner Cover - NEC IT3510 Operation Manual

NEC IT Series
9.4
NEC IT3510/IT2510 Operations Manual
7. Closer the toner cover.
i
The toner is automatically supplied to the unit after the toner bottle cover is
closed. Do not turn off the power, or open this cover while the tone is being
supplied.
It may be impossible to remove the toner bottle if the cover is opened
while the bottle is being rotated. In this case, close the cover, and try
again a short time later.
i
Toner Supply:
If the print is still faint immediately after toner replacement, execute the toner supply
procedure. For details on this procedure, refer to Section 5 Toner Replenishment in
Chapter 8 Troubleshooting on page 8-36.

Installing and Replacing the Transmission (TX) Marker Stamp

This procedure illustrates how to install and replace the TX Marker.
Before Starting Operations:
An optional Marker stamp is required.
The TX Marker cannot be used with the 2-Sided Document Feeder.
The TX Marker is a consumable part. Replacement markers must be purchased from
the dealer who sold this product.

Figure 1-71 Closing the Toner Cover

Issue 1
1 - 59