Registering Passwords For Secured Communications - NEC IT3510 Operation Manual

NEC IT Series
2.11
NEC IT3510/IT2510 Operations Manual

Registering Passwords for Secured Communications

Passwords can be registered that allow both reception and transmission of
facsimiles only when a match is made with the reception or transmission site.
These passwords offer a level of security so the facsimile is sent to, or
received by, the correct party. This section describes registering a password
to carry out password communications.
Before Starting Operations:
A communication password is used for Password Transmission or Password
Reception.
The password-protected transmission (Password TX On) setting is reset upon
completion of each transmission.
Settings in Chapter 4 Advanced Registration and Setting Operations on page 4-1.
The factory default setting is Password not required for reception (Communication
Password:00). For details, refer to Section 3.3 Selecting Password Reception in
Chapter 6 Advanced Sending and Receiving Operations on page 6-38.
Registering the Password for Password Communications
1.
Touch [Initial Setting] on the
Administrator Management
screen.
Refer to Section 2.2 Accessing
the Administrator Management
Screen on page 3-12.
2.
Select [Func.] and touch [Com.
Password].
For details, refer to Section 2.1 Transmission
Issue 1
3 - 31