Adding An Snmpv3 Destination - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

10

Adding an SNMPv3 destination

4. Click Add.
5. Click OK on the SNMP Setup dialog box.
Adding an SNMPv3 destination
You can only configure six destinations, including v1 and v3 destinations.
To add a V3 destination, complete the following steps.
1. Select Monitor > SNMP Setup.
2. Click the Trap Forwarding tab.
3. Select V3 from the Trap forwarding type list.
4. Enter a user name in the User Name field.
5. (Optional) Enter a context name in the Context Name field.
6. Select the authorization protocol in the Auth Protocol field.
7.
8. Select the privacy protocol in the Priv Protocol field.
9. Enter the privacy password in the Priv Password field and the Retype Password field.
10. Click Add.
11. Click OK on the SNMP Setup dialog box.
280
The Add/Edit Trap Recipient dialog box displays.
a. (Optional) In the Description field, enter a description of the trap recipient.
b. In the IP Address field, enter the trap recipient's IP address.
The Management application accepts IP addresses in IPv4 or IPv6 formats.
c. Enter the trap recipient's UDP port number, in the port field.
d. Click OK on the Add/Edit Trap Recipient dialog box.
The SNMP Setup dialog box displays.
Enter the authorization password in the Auth Password field and the Retype Password field.
The Add/Edit Trap Recipient dialog box displays.
a. (Optional) In the Description field, enter a description of the trap recipient.
b. In the IP Address field, enter the trap recipient's IP address.
The Management application accepts IP addresses in IPv4 or IPv6 formats.
c. Enter the trap recipient's UDP port number, in the port field.
d. Click OK on the Add/Edit Trap Recipient dialog box.
DCFM Enterprise User Manual
53-1001775-01