Brocade Communications Systems Brocade 8/12c Command Reference Manual page 58

22
ag
--mapshow [N_Port | device_WWN]
--mapset N_Port [F_Port1;F_Port2;...]
--mapadd N_Port F_Port1 [; F_Port2;...]
--mapdel N_Port F_Port1 [; F_Port2;...]
--staticadd N_Port F_Port1 [; F_Port2;...]
--staticdel N_Port F_Port1 [; F_Port2;...]
--pgshow [pgid]
--pgcreate pgid
--pgadd pgid "N_Port1 [; N_Port2;...]"
--pgdel pgid "N_Port1 [; N_Port2;...]"
--pgrename pgid newname
24
Displays the F_Ports that are configured and currently mapped to a given
"primary" N_Port. Optionally specify an N_Port to display the F_Ports that are
mapped to the specified N_Port only, or specify a device WWN to display the
N_Port to which the device WWN is mapped. Failover and failback policies are
displayed as enabled (1) or disabled (0).
Maps a set of F_Ports to a specified "primary" N_Port forcing all traffic from the
F_Ports to be routed through this N_Port to the attached fabric. An F_Port cannot
be mapped to more than one primary N_Port at any given time. F_Ports are
enabled only if the N_Port is online. This command overwrites existing port
mappings. Use a blank list ("") to clear current mappings.
Adds one or more specified F_Ports to the mapping of an existing "primary"
N_Port. The traffic for the configured F_Ports is routed to the fabric through the
specified N_Port when the F_Ports come online. An F_Port cannot be mapped to
more than one primary N_Port at the same time.
Deletes one or more specified F_Ports from the "primary" N_Port mapping.
Creates a static mapping between an existing "primary" N_Port and one or more
specified F_Ports. This command removes exiting mappings. Once the static
mapping is enabled, the F_Ports and all logged-in devices will logout of the
previous N_Port and login using the new N_Port.
Deletes a static mapping between an existing "primary" N_Port and one or more
specified F_Ports. This command removes exiting mappings. Alternately, you can
remove an existing mapping by mapping the F_Port to another N_Port.
Displays the Port Group configuration. The port grouping feature supports
specifying a set of N_Ports to be included in the Port Group (PG) Policy. The
factory default PG is "pg0", which includes all N_Ports. The default PG cannot be
removed or renamed.
"N_Port1 [;N_Port2;...]" [-n pgname][-m "lb; mfnm"]
Creates a port group with the ID pgid and a specified list of N_Ports to be
included in the policy. The list must be enclosed in quotation marks. Ports must be
separated by semicolons. The Port Group ID must not exceed 64 characters.
Optionally specify a name for the port group and a mode. Modes are by default
disabled. For an explanation of mode values, refer to --pgsetmodes.
Adds one or more N_Ports to the specified port group. The port list must be
enclosed in quotation marks. Ports must be separated by semicolons.
Deletes one or more N_Ports from the specified port group. Deleted ports are
added to the default port group "pg0". The port list must be enclosed in quotation
marks. Ports must be separated by semicolons.
Replaces the name of an existing port group with the specified new name. The
port group ID must not exceed 64 characters.
Fabric OS Command Reference
53-1001764-01