Fanenable - Brocade Communications Systems Brocade 8/12c Command Reference Manual

22

fanEnable

fanEnable
Enables a fan unit.
SYNOPSIS
fanenable unit
DESCRIPTION
Use this command to set a previously disabled fan unit back to the default RPM speed.
NOTES
This command is not available on nonbladed systems except for the Brocade 5300.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
This command has the following operand:
unit
EXAMPLES
To enable a fan unit:
SEE ALSO
fanDisable,
258
Specify the fan unit number to enable.
switch:admin> fanenable 1
Fan unit 1 has been enabled
fanShow
Fabric OS Command Reference
53-1001764-01