Cfgcreate - Brocade Communications Systems Brocade 8/12c Command Reference Manual

22

cfgCreate

cfgCreate
Creates a zone configuration.
SYNOPSIS
cfgcreate "cfgName", "member[;member...]"
DESCRIPTION
Use this command to create a new zone configuration.
This command changes the Defined Configuration (see cfgShow). For the change to become effective,
enable the configuration with the cfgEnable command. For the change to be preserved across switch
reboots, save the configuration to nonvolatile memory with the cfgSave command.
Refer to the zoneCreate command for more information on name and member specifications.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
When an FCS policy is enabled, this command can be issued only from the primary FCS switch.
OPERANDS
The following operands are required:
"cfgName"
"member"
EXAMPLES
To create a configuration containing three zones:
SEE ALSO
cfgAdd, cfgClear, cfgDelete, cfgDisable, cfgEnable, cfgRemove, cfgSave,
96
Specify a name for the zone configuration in double quotation marks. A zone
configuration name must begin with a letter followed by any number of letters,
numbers, and underscores. Names are case-sensitive. For example, "Cfg_1" and
"cfg_1" are different zone configurations. Blank spaces are ignored.
Specify a zone member or list of zone members to be added to the configuration.
The list must be enclosed in double quotation marks. Members must be separated
by semicolons. The zone configuration member list must have at least one
member. Empty member lists are not allowed.
switch:admin> cfgcreate "USA_cfg",
"Purple_zone;Blue_zone;Green_zone"
\
Fabric OS Command Reference
cfgShow
53-1001764-01